TRIMEC ELT 62 / N

• Screw diameter 62 mm

• L / D ratio 1.22

• Reduction unit with case-hardened, hardened and ground transmission parts

• Extended grinding also on the involute of the tooth

• Forced lubrication a / m 0.5 KW electric pump and heat exchanger  heat

• Screws and extrusion cylinder made of nitriding steel  type 41 CrAlMo7, nitrided with  mirror finishes

• The screws are internally drilled along the entire length for  allow the passage of oil  diathermic regulated by a special thermostat control unit

• Heating power 4.5 KW

• Extrusion cylinder heated by / by means of electric resistances in  ceramic

• Total installed power KW 13.6

• Cylinder insulation casing in AISI 304 stainless steel

• Water-cooled cylinder feeding area with relative  room

• Dosing-feeder driven by gear motor. 1.5 motor  KW

• Degassing unit with 1.5 mm liquid ring vacuum pump  KW

• Vacuum gauge for adjustment  of emptiness

• Series of pipes and tanks for dust collection

• 28 kW ac control motor with auxiliary electric fan  controlled by Inverter

• Mechanical joint for connection between motor and gearbox

ELECTRICAL CABINET

For extruder control and temperature control including:

• PID thermoregulators range 0-400 C °

• Inverter for ac motors

• Indicator of extruder screw revolutions and doser screw revolutions

• Ammeters

• Mass pressure and temperature sensing transducer  purr

• Start / stop buttons

• Machine stop button

Extruder length 3500mm

Width 900 mm

Height 2600 mm

Weight kg  2,100

​

​

➢  NEW EXTRUDER AT REVISED PRICE